How to Furl the Jib / Genoa
Back to Basics Sailing Tips
In this episode, we are going right back to the basics to furl away to the jib/ genoa. It is as simple as pulling on the furling line and easing the jib sheet. Watch as Joe Fox walks through all the steps.
This demonstration was done on the Lagoon 42 and is intended to give you confidence in your catamaran handling ability.
We will cover
How to wrap the jib or genoa around the forestay:
1) Check and maintain your heading
2) Pull on the furling line
3) Ease the sheet
4) Tidy up
Check and Maintain your Heading
You can do this in any wind angle, except head to wind.
This is because the sail will become a flag, flapping around and making lots of noise which could potentially damage the sail.
Use the autopilot to help maintain your heading, either under the power of the mainsail or with the engines running.
Pull on the Furling Line
We will be doing the opposite of ‘Un-furling the Jib / Genoa’
On the Lagoon 42 the furling line is a grey line that runs down the Port side of the boat.
Pull on the furling line by hand in light wind, or by putting a few turns around a winch and winching it on in a heavier breeze.
Ease the Sheet
Simultaneously, with a few wraps around the winch, open the clutch and gently ease out the jib sheet, allowing the sail to move forward as the furling line wraps it around the forestay.
In a very light breeze (like in the video) you can just do this by hand, then run down to the furling line and continue to furl the sail.
When easing, you want to ease the sheet enough that there isn’t too much pressure in the sail which will place unnecessary strain on the winch or other components, while maintaining enough sheet pulled in to prevent the sail from flapping around.
If you are sailing on your own you can run the furling line up to the helm station, however, two people certainly make this easier.
It’s always nice to get your guests involved… you don’t want them to get too much of a free ride 🙂
From the stern, you can see when the jib is completely furled. Lock the cleat on the furling line so it won’t unravel, then go and pull in the slack on the sheets at the helm station and tidy up the lines.
There you go!
LATEST FROM THE INSPIRE AND LEARN SERIES
In this episode, we will delve into the art of sail trimming when sailing downwind. Whether you’re a seasoned sailor or just beginning to explore the boating world, understanding the nuances of sail trim can significantly enhance your boat handling abilities. Join our expert team as we provide insights, tips, and techniques to help you optimise your downwind sailing experience.
In this blog, we will look at how to trim your sails when sailing upwind. Sailing upwind is classified as sailing at any angle lower than 90 degrees to the wind. Sailing directly into the wind is not possible; therefore, to sail in the direction of the wind, you must continuously tack in a zig zagging motion.
In this episode, Joe teaches us how to prevent chafing and what the critical chafing points are on a cruising catamaran.